Shed Delivery Access Checklist: Will It Fit in Your Backyard?
Last updated September 14, 2026
A fully built shed arrives on a trailer and has to travel from the street to its pad. Before you order, walk that route and check the width at the narrowest point, every turn, gate openings, overhead wires and branches, slope, soft ground and septic or utility lines. Send the dealer photos and measurements. Most sites work, many need a shed mule for the last stretch, and a few need a smaller building or a different spot. The dealer confirms the specifics for the building you choose.
The most common delivery-day problem is not the pad. It is the path. A building that measures 12 feet wide needs more than 12 feet of clear width the whole way from the street to the spot, plus room to turn and to slide it into position. This checklist walks the route the way a delivery driver would. Do it before you order, not the night before delivery, because the answer sometimes changes which building you should buy. Everything here is general guidance; the dealer will tell you the exact requirements for the specific building and the equipment they use.
Start at the street
- Can a pickup truck with a long trailer get onto your road and into your driveway? Tight rural roads, dead ends with no turnaround and steep driveway aprons are all worth mentioning.
- Is there a place to park the truck and trailer while the building is moved the rest of the way? A trailer parked on a busy road for an hour is a problem.
- Are there low-hanging wires at the road, the driveway entrance or a gate? A building on a trailer sits higher than the building will sit on its pad.
Measure the path width
Walk from where the trailer will park to the pad and measure the narrowest point: between the house and the fence, between two trees, through a gate, past an air conditioner or a well head. As a rule of thumb, the clear path needs to be wider than the building by a couple of feet on each side when the building is moved on the trailer, and by at least a foot or so on each side when it is moved with a mule. Write the narrowest width down. If it is close, ask the dealer whether the building can be turned and moved lengthwise, which changes the width you need.
Check every turn
A straight, narrow path is easier than a wide path with a tight corner. At each turn, picture the full length of the building swinging around it. A 24-foot building turning a corner between a house and a garage needs far more room than the width alone suggests. Corners near the house, at the end of a driveway, or around a deck are the usual trouble spots. If a turn looks tight, photograph it from both directions.
Gates and fences
- Measure the actual opening between gate posts, not the gate panel.
- Note whether the gate can be lifted off, or a fence section removed and put back, which is common for backyard deliveries.
- Check what is on the other side of the gate: a step down, a retaining wall, a swimming pool fence.
Overhead clearance
Look up along the whole route. Tree limbs, service drops to the house, clotheslines, eaves, carport roofs and satellite dishes all matter. A building on a trailer can stand well above the height it will sit at on the pad, and a lofted barn or a cabin with a tall roof is higher still. Ask the dealer for the loaded height of the building you are considering and compare it to the lowest thing over the route. Small branches can be trimmed; a service drop cannot be moved by the delivery crew.
Slope and grade
Delivery equipment handles gentle grades well and steep ones poorly, especially side slopes, where a building on a trailer wants to lean. Note any hill along the route, the direction of the slope and whether it is grass, gravel or pavement. A sloped pad site is a separate question: buildings are leveled on blocks, but a site that drops more than a couple of feet across the length of the building usually needs to be cut or built up first. The site prep guide covers pads.
Ground conditions
- Soft lawn after rain, spring thaw and irrigated turf all rut under a loaded trailer. Ask the dealer whether they will drive on grass and whether they use mats.
- Septic tanks, drain fields, leach lines, sprinkler heads and shallow utility lines can be crushed. Mark them and tell the crew.
- Sand, mud and loose gravel can stop a trailer on even a mild grade.
- Frozen ground is fine to drive on; half-thawed ground is the worst.
The mule method for tight sites
Many dealers use a shed mule: a compact, powered machine that lifts one end of the building and moves it on its own wheels, with the delivery trailer left at the street. A mule can turn in its own length, pass through a gate a trailer cannot, and cross a lawn with less damage. It still needs the width of the building plus working room, firm ground and reasonable grade. If the path is tight, ask whether the dealer uses a mule and what clearance it needs; the shed mule delivery guide explains how it works. If there is no mule route either, the options are a smaller building, a different site on the property, a building delivered in sections, or a crane, which is a separate cost.
Photos and measurements to send the dealer
- A photo from the street looking down the driveway, and one from the driveway looking back at the street.
- A photo of each narrow point and each turn, with a tape measure in the frame or the width written in the message.
- A photo of every gate, with the opening width.
- A photo looking up along the route showing wires and branches.
- A photo of the pad site from where the building will approach it, plus one showing the slope across it.
- A rough sketch or a satellite screenshot with the route drawn on it and the pad marked.
- The narrowest width, the lowest overhead point and the steepest grade, in feet.
Delivery day
- Move vehicles, trailers, grills, planters and anything else out of the route.
- Take the gate off or the fence section down if that was the plan.
- Mark sprinkler heads, septic lids and buried lines with flags.
- Be there, or have someone there who can make a decision about placement.
- Have the pad finished and level. The crew levels the building on blocks; it does not build the pad.
These are rules of thumb, not promises. Path widths, heights and grades depend on the specific building, the trailer and mule the dealer uses, and the ground on the day. Send the photos, ask the questions, and let the dealer confirm before you order. If the dealer says a site will not work, believe them; the alternative is a building stuck in the driveway.
Common questions
- How do I find a rent-to-own shed dealer near me?
- Search the RentToOwnSheds.com directory by city, ZIP code, or state to see local dealers, then contact a dealer directly to confirm current inventory, delivery area, pricing, and rent-to-own terms. Many dealers deliver the building fully built to your property.
Ready to find a building?
Browse local dealers or estimate a monthly payment in seconds.
Keep reading
This guide is general information, not legal, financial, or code advice. Rules, pricing, and availability vary by state, local government, dealer, and rent-to-own provider. Always confirm current requirements and terms before ordering.